Griffon 6150450 PolyMax Fix & Seal Express white 425g
Special features
- Very high, permanent elasticity
- Very rapid strength development
- Very good filling capacity
- Good sag resistance
- Does not shrink, 100% adhesive
- Solvent-free
- Does not soil edges
- Weather resistant
- Temperature resistant from -40°C to +100°C
- Paintable
- Curing approx. 2 mm/24 hours
- Solvent-free assembly adhesive and sealant with very high elasticity and very rapid strength development based on SMP Polymer. Ideal for mounting in combination with sealing
- For bonding and mounting many building materials on virtually all substrates, such as wood, (natural) stone, (aerated) concrete, metal, rigid foam, and PLS plastics
- Suitable for indoor and outdoor applications, such as framing, skirting boards, battens, window sills, and sheet and insulation materials
- Also suitable for sealing joints, seams, and gaps in (plastic) frames, fascia boards, roofs, gutters, walls, skylights, and chimneys
- For all professional applications, such as facade and interior construction, residential, commercial, and automotive construction
Technical data
- Not suitable for PE, PP, PTFE, pure gypsum, and bitumen. Always perform an adhesion test first when bonding plastic. Adhesion to plastic may vary depending on the type and quality of the plastic. Remove wet adhesive residue immediately with turpentine. Dried adhesive residue can only be removed mechanically. Consumption: For spot bonding: 5-8 m²/kg. Strips: approx. 8-15 meters of glue comes from 1 tube (depending on the diameter of the cut nozzle)
- Store dry in a closed container between +5°C and +25°C
- Contents: 425 g
Instructions for use
- GLUING/ASSEMBLY: Cut off the thread, mount the nozzle and cut it to a diameter of min. 0.5 cm
- Apply glue evenly in vertical stripes or dots every 10 to 40 cm, depending on the weight of the material
- Always apply glue to corners and along edges
- Assemble materials immediately with a sliding motion and press or tap firmly. Correction is still possible
- For heavy materials, fix or support if necessary
- Close the cartridge tightly immediately after use
- Sealing: Cut off the thread, mount the nozzle, and cut at an angle to the desired joint width
- Apply sealant to the bottom of the joint and smooth within 10 minutes with a wet finger (water with dishwashing liquid without lemon), putty knife, or sealant trowel
- Smooth vertical joints from bottom to top
- Close the cartridge tightly immediately after use
- The ambient temperature, the adhesive, and the materials to be bonded must not be lower than +5°C
- Parts must be clean, dust-free, and grease-free. Ensure a firm surface. The surface may be slightly damp. Use of primer is not necessary
- Before use, open the cartridge at the top by cutting off the plastic nipple above the thread with a sharp knife. Next, attach the nozzle and cut it at an angle (min. Ø 5 mm opening).
Comment